Light Up Your Life Candlestick Lamp

Candlestick Lamp
You don’t need to be a professional electrician to make your own candlestick lamp. With a bottle adapter lamp kit from the hardware store, all that’s left for you to do is find the perfect flea market candlestick and follow these simple instructions. In minutes, you’ll have a working candlestick lamp. To embellish the lampshade for your boudoir, choose an ornate rubber stamp, a paint color that complements your candlestick, and glitzy beaded fringe. With the flick of a switch, you’ll be reading by “candle light.”



To make the lamp, you will need:
candlestick, 8 inches tall (made for a taper candle with a 5/8-inch to one-inch diameter)
bottle adapter “Make-a-Lamp” kit
light bulb
screwdriver
rubber bands

To embellish the lampshade, you will need:
white clip lampshade (clip attaches to the bulb), 7 inches tall, 9-inch diameter at bottom
metallic silver acrylic paint, 2 fl. oz.
squeeze bottle of iridescent glitter paint, 2 fl. oz.
rubberstamp, 4 inches across
crystal beaded fringe, 29 inches long
hot glue gun
hot glue


How To Assemble The Lamp:
Step 1
Select the rubber adapter from the bottle adapter “Make-a-Lamp” kit that fits the candlestick opening. Slide the adapter all the way onto one end of the threaded pipe.




Step 2
Screw the socket bottom onto the threaded pipe.



Step 3
Tighten the side screw with a screwdriver.


Step 4
Feed the loose-wire end of the electrical cord through the hole in the side of the socket bottom. 


Step 5
Pull the cord apart to create some slack, then tie the ends in a knot. This will keep the cord from pulling out of the socket cap.


Step 6
Connect the neutral wire to the silver screw (the rubber insulation on the neutral wire is ribbed) and tighten with a screwdriver. 


Step 7
Connect the other wire to the brass screw and tighten with a screwdriver. Make sure the brass tips of the wires are secured under the screw heads.


Step 8
Slide the brass shell with the paper liner over the lamp socket. Snap the brass shell onto the socket bottom and rock it into place until it clicks.


Tight Light: If the rubber adapter feels a little loose in the candlestick, make a tighter fit by wrapping the adapter with a rubber band or two.


How To Embellish The Lampshade:
Step 1
Using the rubber stamp and the silver acrylic paint, stamp the image four times around the bottom edge of the lampshade. (For even spacing, stamp on one side, then turn the shade 180 degrees, and stamp again opposite the first image. Then repeat between the two stamped images.) Turn the rubber stamp upside-down and stamp around the top edge of the lampshade four times between the bottom stamped images.



Step 2
When the paint is dry, trace the edges of each stamped image with the squeeze bottle of iridescent glitter paint.

Step 3
When the glitter paint is dry, hot glue the beaded fringe around the bottom edge of the lampshade. To finish off your lamp, insert the lamp fixture into the candlestick, screw in a light bulb and attach the lampshade to the bulb. Then light up the night!



Keep It Clean: For a cleaner stamped image, dab the paint directly onto the rubber stamp. Try a few test stamps on a scrap piece of paper until you get the hang of it.



Perfect Pair
For twice the fun, buy a pair of candlesticks and turn them into matching lamps for your bedside tables.

Share a Comment

*